We have at out disposal:

a plasma cutter with the gauge of 40 mm.

The plasma cutter is utilized at the beginning of thermic cutting. In particular the plasma transfers the heat to the metal material to make it reach a melting point and cut a steel sheet.

The plasma cutting is specially indicated for the slim sheets of inoxidizable steel and light alloys cut with a relatively low level of electrical consumption owing to the soft and sharp plasma pillar. The minimum gauge cut by the plasma amounts to 0.5 mm with the matched surface. Besides the plasma doesn’t thermally deform slim gauges letting the latter be cut with a good quality at the fair prices (that are lower than the prices for both the laser cutting and the oxyacetylene one).

Due to the abovementioned the plasma cutting by an air or oxygen pistol turns out specially indicated for the carcass cutting of household appliance, moreover the plasma cutting with the use of water or protective gas is much more simple and economic. It is really one of the preferred systems for the steel sheets’ cutting considered and submitted to the experiments.